Главная страница


ru.cisco

 
 - RU.CISCO ---------------------------------------------------------------------
 From : Vassily Kiryanov                     2:5054/36      27 Feb 2006  22:00:22
 To : All
 Subject : Hе могу etherchannel настроить.
 -------------------------------------------------------------------------------- 
 
 
 Послушал я тут в прошлый раз советов добрых людей и пытаюсь настроить
 etherchannel между парой цисок, 2950 и 3745.
 Hа коммутаторе, вроде, нормально всё. А на маршрутизаторе - не могу понять, не
 показывает он этого etherchannel хоть тресни.
 Привожу пару файлов, гуру, гляньте что у меня не так.
 
 Это с коммутатора:
 === Cut ===
 cisco29#show ether 1 det
 Group state = L2
 Ports: 2   Maxports = 8
 Port-channels: 1 Max Port-channels = 1
 Protocol:   PAgP
   Ports in the group:
   -------------------
 Port: Fa0/1
 ------------
 
 Port state    = Up Sngl-port-Bndl Mstr Not-in-Bndl
 Channel group = 1           Mode = Automatic-Sl     Gcchange = 0
 Port-channel  = null        GC   = 0x00010001          Pseudo port-channel = Po1
 Port index    = 0           Load = 0x00        Protocol =   PAgP
 
 Flags:  S - Device is sending Slow hello.  C - Device is in Consistent state.
         A - Device is in Auto mode.        P - Device learns on physical port.
         d - PAgP is down.
 Timers: H - Hello timer is running.        Q - Quit timer is running.
         S - Switching timer is running.    I - Interface timer is running.
 
 Local information:
                                 Hello    Partner  PAgP     Learning  Group
 Port      Flags State   Timers  Interval Count   Priority   Method  Ifindex
 Fa0/1     A U2/S4    1s  0        128        Any      1
 
 Age of the port in the current state: 00d:05h:45m:07s
 
 Port: Fa0/24
 ------------
 
 Port state    = Up Sngl-port-Bndl Mstr Not-in-Bndl
 Channel group = 1           Mode = Automatic-Sl     Gcchange = 0
 Port-channel  = null        GC   = 0x00010001       Pseudo port-channel = Po1
 Port index    = 0           Load = 0x00        Protocol =   PAgP
 
 Flags:  S - Device is sending Slow hello.  C - Device is in Consistent state.
         A - Device is in Auto mode.        P - Device learns on physical port.
         d - PAgP is down.
 Timers: H - Hello timer is running.        Q - Quit timer is running.
         S - Switching timer is running.    I - Interface timer is running.
 
 Local information:
                                 Hello    Partner  PAgP     Learning  Group
 Port      Flags State   Timers  Interval Count   Priority   Method  Ifindex
 Fa0/24    A U2/S4    1s  0        128        Any      24
 
 Age of the port in the current state: 00d:05h:45m:08s
 
   Port-channels in the group:
   ----------------------
 
 Port-channel: Po1
 ------------
 
 Age of the Port-channel   = 04d:03h:07m:30s
 Logical slot/port   = 1/0          Number of ports = 0
 GC                  = 0x00000000      HotStandBy port = null
 Port state          = Port-channel Ag-Not-Inuse
 Protocol            =   PAgP
 cisco29#show ether 1 sum
 Flags:  D - down        P - in port-channel
         I - stand-alone s - suspended
         H - Hot-standby (LACP only)
         R - Layer3      S - Layer2
         u - unsuitable for bundling
         U - in use      f - failed to allocate aggregator
         d - default port
 
 Number of channel-groups in use: 1
 Number of aggregators:           1
 
 Group  Port-channel  Protocol    Ports
 ------+-------------+-----------+---------------------------------------------- 
 -
 1      Po1(SD)         PAgP      Fa0/1(I)    Fa0/24(I)
 === Cut ===
 Это с маршрутизатора:
 
 === Cut ===
 cisco37#show eth 1 sum
 Flags:  D - down        P - in port-channel
         I - stand-alone s - suspended
         R - Layer3      S - Layer2
         U - in use
 Group Port-channel  Ports
 -----+------------+-----------------------------------------------------------
 
 cisco37#show eth 1 det
   <1-64>  Port-channel interface number
 
 cisco37#show int port 1
 Port-channel1 is up, line protocol is up
   Hardware is FEChannel, address is 000e.84a3.c830 (bia 000e.84a3.c830)
   Description: myetherchannel
   MTU 1500 bytes, BW 200000 Kbit, DLY 100 usec,
      reliability 255/255, txload 1/255, rxload 1/255
   Encapsulation ARPA, loopback not set
   Keepalive set (10 sec)
   ARP type: ARPA, ARP Timeout 04:00:00
     No. of active members in this channel: 2
         Member 0 : FastEthernet0/0 , Full-duplex, 100Mb/s
         Member 1 : FastEthernet0/1 , Full-duplex, 100Mb/s
     No. of Non-active members in this channel: 0
   Last input never, output never, output hang never
   Last clearing of "show interface" counters never
   Input queue: 0/150/0/0 (size/max/drops/flushes); Total output drops: 0
   Queueing strategy: fifo
   Output queue: 0/80 (size/max)
   5 minute input rate 117000 bits/sec, 40 packets/sec
   5 minute output rate 116000 bits/sec, 39 packets/sec
      0 packets input, 0 bytes
      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
      0 watchdog
      0 input packets with dribble condition detected
      27 packets output, 2079 bytes, 0 underruns
      0 output errors, 0 collisions, 0 interface resets
      0 babbles, 0 late collision, 0 deferred
      0 lost carrier, 0 no carrier
      0 output buffer failures, 0 output buffers swapped out
 === Cut ===
 
 Всего хорошего.              "За верную и прибыльную дружбу!" (c) Яго.
                 Vassily
 ---
  * Origin: И бьется против геноцида Вася, и против Васи геноцид. (2:5054/36)
 
 

Вернуться к списку тем, сортированных по: возрастание даты  уменьшение даты  тема  автор 

 Тема:    Автор:    Дата:  
 Hе могу etherchannel настроить.   Vassily Kiryanov   27 Feb 2006 22:00:22 
 Hе могу etherchannel настроить.   Aleksey Alekseev   28 Feb 2006 08:24:23 
 Hе могу etherchannel настроить.   Vassily Kiryanov   28 Feb 2006 10:48:40 
Архивное /ru.cisco/185144036bc8.html, оценка 3 из 5, голосов 10
Яндекс.Метрика
Valid HTML 4.01 Transitional