|
ru.cisco
- RU.CISCO ---------------------------------------------------------------------
From : Aleksey Alekseev 2:5020/400 28 Feb 2006 08:24:23
To : Vassily Kiryanov
Subject : Hе могу etherchannel настроить.
--------------------------------------------------------------------------------
чего не работает то?
Mon Feb 27 2006 20:00, Vassily Kiryanov wrote to All:
VK> Hi All!
VK> Послушал я тут в прошлый раз советов добрых людей и пытаюсь настроить
VK> etherchannel между парой цисок, 2950 и 3745.
VK> Hа коммутаторе, вроде, нормально всё. А на маршрутизаторе - не могу
VK> понять, не показывает он этого etherchannel хоть тресни.
VK> Привожу пару файлов, гуру, гляньте что у меня не так.
VK> Это с коммутатора:
VK> === Cut ===
VK> cisco29#show ether 1 det
VK> Group state = L2
VK> Ports: 2 Maxports = 8
VK> Port-channels: 1 Max Port-channels = 1
VK> Protocol: PAgP
VK> Ports in the group:
VK> -------------------
VK> Port: Fa0/1
VK> ------------
VK> Port state = Up Sngl-port-Bndl Mstr Not-in-Bndl
VK> Channel group = 1 Mode = Automatic-Sl Gcchange = 0
VK> Port-channel = null GC = 0x00010001 Pseudo
VK> port-channel = Po1 Port index = 0 Load = 0x00
VK> Protocol = PAgP
VK> Flags: S - Device is sending Slow hello. C - Device is in Consistent
VK> state.
VK> A - Device is in Auto mode. P - Device learns on physical
VK> port.
VK> d - PAgP is down.
VK> Timers: H - Hello timer is running. Q - Quit timer is running.
VK> S - Switching timer is running. I - Interface timer is
VK> running.
VK> Local information:
VK> Hello Partner PAgP Learning
VK> Group Port Flags State Timers Interval Count Priority Method
VK> Ifindex Fa0/1 A U2/S4 1s 0 128 Any 1
VK> Age of the port in the current state: 00d:05h:45m:07s
VK> Port: Fa0/24
VK> ------------
VK> Port state = Up Sngl-port-Bndl Mstr Not-in-Bndl
VK> Channel group = 1 Mode = Automatic-Sl Gcchange = 0
VK> Port-channel = null GC = 0x00010001 Pseudo port-channel =
VK> Po1 Port index = 0 Load = 0x00 Protocol = PAgP
VK> Flags: S - Device is sending Slow hello. C - Device is in Consistent
VK> state.
VK> A - Device is in Auto mode. P - Device learns on physical
VK> port.
VK> d - PAgP is down.
VK> Timers: H - Hello timer is running. Q - Quit timer is running.
VK> S - Switching timer is running. I - Interface timer is
VK> running.
VK> Local information:
VK> Hello Partner PAgP Learning
VK> Group Port Flags State Timers Interval Count Priority Method
VK> Ifindex Fa0/24 A U2/S4 1s 0 128 Any 24
VK> Age of the port in the current state: 00d:05h:45m:08s
VK> Port-channels in the group:
VK> ----------------------
VK> Port-channel: Po1
VK> ------------
VK> Age of the Port-channel = 04d:03h:07m:30s
VK> Logical slot/port = 1/0 Number of ports = 0
VK> GC = 0x00000000 HotStandBy port = null
VK> Port state = Port-channel Ag-Not-Inuse
VK> Protocol = PAgP
VK> cisco29#show ether 1 sum
VK> Flags: D - down P - in port-channel
VK> I - stand-alone s - suspended
VK> H - Hot-standby (LACP only)
VK> R - Layer3 S - Layer2
VK> u - unsuitable for bundling
VK> U - in use f - failed to allocate aggregator
VK> d - default port
VK> Number of channel-groups in use: 1
VK> Number of aggregators: 1
VK> Group Port-channel Protocol Ports
VK> ------+-------------+-----------+----------------------------------------
VK> ------ - 1 Po1(SD) PAgP Fa0/1(I) Fa0/24(I)
VK> === Cut ===
VK> Это с маршрутизатора:
VK> === Cut ===
VK> cisco37#show eth 1 sum
VK> Flags: D - down P - in port-channel
VK> I - stand-alone s - suspended
VK> R - Layer3 S - Layer2
VK> U - in use
VK> Group Port-channel Ports
VK> -----+------------+------------------------------------------------------
VK> -----
VK> cisco37#show eth 1 det
VK> <1-64> Port-channel interface number
VK> cisco37#show int port 1
VK> Port-channel1 is up, line protocol is up
VK> Hardware is FEChannel, address is 000e.84a3.c830 (bia 000e.84a3.c830)
VK> Description: myetherchannel
VK> MTU 1500 bytes, BW 200000 Kbit, DLY 100 usec,
VK> reliability 255/255, txload 1/255, rxload 1/255
VK> Encapsulation ARPA, loopback not set
VK> Keepalive set (10 sec)
VK> ARP type: ARPA, ARP Timeout 04:00:00
VK> No. of active members in this channel: 2
VK> Member 0 : FastEthernet0/0 , Full-duplex, 100Mb/s
VK> Member 1 : FastEthernet0/1 , Full-duplex, 100Mb/s
VK> No. of Non-active members in this channel: 0
VK> Last input never, output never, output hang never
VK> Last clearing of "show interface" counters never
VK> Input queue: 0/150/0/0 (size/max/drops/flushes); Total output drops: 0
VK> Queueing strategy: fifo
VK> Output queue: 0/80 (size/max)
VK> 5 minute input rate 117000 bits/sec, 40 packets/sec
VK> 5 minute output rate 116000 bits/sec, 39 packets/sec
VK> 0 packets input, 0 bytes
VK> Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
VK> 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
VK> 0 watchdog
VK> 0 input packets with dribble condition detected
VK> 27 packets output, 2079 bytes, 0 underruns
VK> 0 output errors, 0 collisions, 0 interface resets
VK> 0 babbles, 0 late collision, 0 deferred
VK> 0 lost carrier, 0 no carrier
VK> 0 output buffer failures, 0 output buffers swapped out
VK> === Cut ===
VK> Всего хорошего. "За верную и прибыльную дружбу!" (c) Яго.
VK> Vassily
ВОЛКА
--- ifmail v.2.15dev5.3
* Origin: FidoNet Online - http://www.fido-online.com (2:5020/400)
Вернуться к списку тем, сортированных по: возрастание даты уменьшение даты тема автор
|
Hе могу etherchannel настроить. 