|
ru.cisco
- RU.CISCO ---------------------------------------------------------------------
From : Igor Vorontsov 2:5020/400 02 Jul 2002 13:23:49
To : All
Subject : Cisco 2600 with NM-HDV-1E1-30E and Panasonic 500
--------------------------------------------------------------------------------
Уважаемые коллеги!
Чего-то я не понимаю...
Есть cisco 2621 с NM-HDV-1E1-30E,
подключена к АТС Panasonic 500 c платой PRI30.
Есть удаленная cisco 1750 с FXS-платой.
Схема подключения -
PBX--ISDN PRI---Cisco 2621---FR--Cisco 1750--Phone
Конфиги, sh ver, deb isdn q931 приведены ниже.
При звонке с телефона, подключенного в АТС, на
удаленную 1750 звонок проходит нормально.
При звонке с 1750 на телефон, подключенный к АТС,
слышим сигнал занято. Именно занято, а не более частые гудки
"отказ в обслуживании".
Вылезает при этом ошибка, говорящая о том, что надо бы проверить
настройки D-channel.
Попытки сменить compand-type с a-law на u-law и поставить
на 2621 в dial-peer direct-inward-call ни к чему не приводят. :(
Может кто подскажет как эту проблему можно разрешить?
- --- Cisco 2621 ---
#sh start
version 12.2
no service single-slot-reload-enable
service timestamps debug datetime msec localtime
service timestamps log uptime
no service password-encryption
!
hostname 2621
!
logging rate-limit console 10 except errors
no logging console
!
voice-card 1
!
ip subnet-zero
!
!
no ip finger
no ip domain-lookup
!
no ip dhcp-client network-discovery
isdn switch-type primary-qsig
isdn voice-call-failure 0
call rsvp-sync
!
!
controller E1 1/0
pri-group timeslots 1-31
!
interface FastEthernet0/0
ip address 10.0.0.1 255.255.255.0
duplex auto
speed 100
no cdp enable
!
interface Serial0/0
description Connection to FR
no ip address
encapsulation frame-relay IETF
clockrate 2000000
frame-relay traffic-shaping
frame-relay lmi-type ansi
!
interface Serial0/0.1 point-to-point
description connection to 1750
ip address 192.168.0.1 255.255.255.252
no cdp enable
frame-relay interface-dlci 16 IETF
class map_vofr
vofr cisco
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
no cdp enable
!
interface Serial1/0:15
no ip address
no logging event link-status
isdn switch-type primary-qsig
isdn overlap-receiving
isdn protocol-emulate network
isdn incoming-voice voice
no isdn T309-enable
fair-queue 64 256 0
no cdp enable
!
ip classless
ip route 10.10.0.0 255.255.255.0 192.168.0.2
no ip http server
!
!
map-class frame-relay map_vofr
no frame-relay adaptive-shaping
frame-relay cir 256000
frame-relay bc 2560
frame-relay be 0
frame-relay mincir 256000
frame-relay fair-queue
frame-relay voice bandwidth 64000
frame-relay fragment 320
logging trap debugging
no cdp run
!
voice-port 1/0:15
compand-type a-law
cptone RU
!
dial-peer cor custom
!
!
!
dial-peer voice 10 vofr
destination-pattern 2
session target Serial0/0 16
dtmf-relay
codec g729br8
no vad
!
dial-peer voice 1 pots
incoming called-number ....
destination-pattern 3....
port 1/0:15
!
!
line con 0
transport input none
line aux 0
line vty 0 4
exec-timeout 0 0
login local
line vty 5 15
login
no scheduler allocate
end
#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IS-M), Version 12.2(2)T, RELEASE SOFTWARE
(fc1)
TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Sat 02-Jun-01 21:34 by ccai
Image text-base: 0x80008088, data-base: 0x8118A888
ROM: System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-IS-M), Version 12.2(2)T, RELEASE SOFTWARE (fc1)
el-main uptime is 12 minutes
System returned to ROM by reload at 14:27:56 EEST Thu Jun 13 2002
System image file is "flash:c2600-is-mz.122-2.T.bin"
cisco 2621 (MPC860) processor (revision 0x00) with 59392K/6144K bytes of
memory.
Processor board ID JAD06150M60 (3121046198)
M860 processor: part number 0, mask 49
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
32 Serial network interface(s)
1 Channelized E1/PRI port(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
# deb isdn q931
*Mar 1 00:19:54.235: ISDN Se1/0:15: TX -> SETUP pd = 8 callref = 0x0004
*Mar 1 00:19:54.239: Bearer Capability i = 0x8090A3
*Mar 1 00:19:54.239: Channel ID i = 0xA98381
*Mar 1 00:19:54.243: Calling Party Number i = 0x0080, '2',
Plan:Unknown, Type:Unknown
*Mar 1 00:19:54.243: Called Party Number i = 0x80, '1190',
Plan:Unknown, Type:Unknown
*Mar 1 00:19:54.379: ISDN Se1/0:15: RX <- SETUP_ACK pd = 8 callref =
0x8004
*Mar 1 00:19:54.387: ISDN Se1/0:15: TX -> STATUS pd = 8 callref = 0x0004
*Mar 1 00:19:54.391: Cause i = 0x80E018 - Mandatory information
element missing
*Mar 1 00:19:54.391: Call State i = 0x01
*Mar 1 00:19:54.515: ISDN Se1/0:15: RX <- RELEASE pd = 8 callref = 0x8004
*Mar 1 00:19:54.519: Cause i = 0x81E57D - Message not compatible
with call state
*Mar 1 00:19:54.527: ISDN Se1/0:15: TX -> RELEASE_COMP pd = 8 callref =
0x0004
*Mar 1 00:19:54.527: Cause i = 0x80E07D - Mandatory information
element missing
- --- Cisco 1750 -----
#sh start
version 12.2
service timestamps debug datetime msec localtime
service timestamps log uptime
no service password-encryption
!
hostname 1750
!
memory-size iomem 15
ip subnet-zero
!
!
no ip domain-lookup
!
fax interface-type fax-mail
mta receive maximum-recipients 0
!
!
!
interface FastEthernet0/0
ip address 10.10.0.1 255.255.255.0
speed auto
!
interface Serial0/0
description Connection to central office
bandwidth 128000
ip address 192.168.0.2 255.255.255.252
no ip redirects
encapsulation frame-relay IETF
clockrate 2000000
frame-relay traffic-shaping
frame-relay interface-dlci 16
class map_vofr
vofr cisco
!
ip classless
ip route 10.0.0.0 255.255.255.0 192.168.0.1
no ip http server
ip pim bidir-enable
!
!
!
map-class frame-relay map_vofr
frame-relay cir 256000
frame-relay bc 2560
frame-relay be 0
no frame-relay adaptive-shaping
frame-relay fair-queue
frame-relay voice bandwidth 64000
frame-relay fragment 320
!
call rsvp-sync
!
voice-port 1/0
cptone RU
!
voice-port 1/1
cptone RU
!
!
mgcp profile default
!
dial-peer cor custom
!
!
!
dial-peer voice 10 vofr
destination-pattern 3....
session target Serial0/0 16
dtmf-relay
codec g729br8
no vad
!
dial-peer voice 1 pots
incoming called-number 2
destination-pattern 2
port 1/0
!
dial-peer voice 2 pots
incoming called-number 2
destination-pattern 2
port 1/1
!
!
line con 0
line aux 0
line vty 0 4
exec-timeout 0 0
login local
line vty 5 15
exec-timeout 0 0
login local
!
no scheduler allocate
end
--
Igor Vorontsov
IV-UANIC, IV144-RIPE
CCNA, SCSA, SCWSE
--- ifmail v.2.15dev5
* Origin: ProNet (2:5020/400)
Вернуться к списку тем, сортированных по: возрастание даты уменьшение даты тема автор
|
