Главная страница


ru.cisco

 
 - RU.CISCO ---------------------------------------------------------------------
 From : Ilya S. Abdrakhimov                  2:5020/400     03 Jun 2002  13:50:24
 To : All
 Subject : Cisco3620-E1-Huawei4001
 -------------------------------------------------------------------------------- 
 
 
 Здравствуйте
 
 Кто-нибудь сталкивался с проблемой соединения Cisco3620 и Huawei4001 через
 E1?
 Cisco сконфигурирована по рекомендациям FAQ_ru_cisco,  соответствующие
 настройки сделаны в Huawei.
 Подскажите пожалуйста возможна ли совместная работа этого оборудования и как
 решить эту проблему.
 
 Заранее благодарен за помощь
 
 Илья
 Диагностика следующая:
 
 Cisco:
 cisco 3620 (R4700) processor (revision 0x81) with 26624K/6144K bytes of
 memory.
 R4700 CPU at 80Mhz, Implementation 33, Rev 1.0
 Channelized E1, Version 1.0.
 Primary Rate ISDN software, Version 1.1.
 1 FastEthernet/IEEE 802.3 interface(s)
 62 Serial network interface(s)
 30 terminal line(s)
 2 Channelized E1/PRI port(s)
 OS (tm) 3600 Software (C3620-I-M), Version 12.1(4), RELEASE SOFTWARE (fc1)
 
 sh ru:
 !
 controller E1 0/1
  framing NO-CRC4
  clock source internal
  pri-group timeslots 1-31
 !
 
 interface Serial0/1:15
  ip address 192.168.100.1 255.255.255.0
  encapsulation ppp
  no cdp enable
 !
 
 sh contr e1 1/0:
 E1 0/1 is up.
   Applique type is Channelized E1 - unbalanced
   Far End Block Errors Detected
 ----------------------------------
   No alarms detected.
   Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal.
   Data in current interval (61 seconds elapsed):
      0 Line Code Violations, 0 Path Code Violations
      0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
      0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
 
 sh interfaces serial 0/1:15:
 Serial0/1:15 is up, line protocol is up (spoofing)
   Hardware is DSX1
   Internet address is 192.168.100.1/24
   MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
      reliability 255/255, txload 1/255, rxload 1/255
   Encapsulation PPP, loopback not set
   Last input never, output never, output hang never
   Last clearing of "show interface" counters 3d23h
   Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 80
   Queueing strategy: weighted fair
   Output queue: 0/1000/64/0 (size/max total/threshold/drops)
      Conversations  0/1/256 (active/max active/max total)
      Reserved Conversations 0/0 (allocated/max allocated)
   5 minute input rate 0 bits/sec, 0 packets/sec
   5 minute output rate 0 bits/sec, 0 packets/sec
      0 packets input, 0 bytes, 0 no buffer
      Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
      0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
      0 packets output, 0 bytes, 0 underruns
      0 output errors, 0 collisions, 0 interface resets
      0 output buffer failures, 0 output buffers swapped out
      20 carrier transitions
   Timeslot(s) Used:16, Transmitter delay is 0 flags
 --- ifmail v.2.15dev5
  * Origin: ISU (2:5020/400)
 
 

Вернуться к списку тем, сортированных по: возрастание даты  уменьшение даты  тема  автор 

 Тема:    Автор:    Дата:  
 Cisco3620-E1-Huawei4001   Ilya S. Abdrakhimov   03 Jun 2002 13:50:24 
Архивное /ru.cisco/684eeac2af8.html, оценка 2 из 5, голосов 10
Яндекс.Метрика
Valid HTML 4.01 Transitional