ru.cisco

 
 - RU.CISCO ---------------------------------------------------------------------
 From : Alexander V. Klepikov                2:5020/400     16 Feb 2007  15:42:14
 To : All
 Subject : High CPU load
 -------------------------------------------------------------------------------- 
 

 Hello, All!
 
 Скажите, для 2651XM это нормально?
 
 #sh proc cpu s | inc util
 CPU utilization for five seconds: 96%/95%; one minute: 86%; five minutes: 
 84%
 
 Hа FastEthernet0/0 с десяток VLAN'ов
 
 #sh int fa0/0 | inc rate
   Queueing strategy: fifo
   5 minute input rate 13115000 bits/sec, 1687 packets/sec
   5 minute output rate 13081000 bits/sec, 1685 packets/sec
 
 #sh ver
 Cisco IOS Software, C2600 Software (C2600-ADVENTERPRISEK9-M), Version 
 12.4(10a), RELEASE SOFTWARE (fc2)
 Technical Support: http://www.cisco.com/techsupport
 Copyright (c) 1986-2006 by Cisco Systems, Inc.
 Compiled Wed 11-Oct-06 18:15 by prod_rel_team
 
 [Sorry, skipped]
 
 Cisco 2651XM (MPC860P) processor (revision 3.1) with 253952K/8192K bytes of 
 memory.
 Processor board ID FOC08310PYP
 M860 processor: part number 5, mask 2
 2 FastEthernet interfaces
 2 Serial(sync/async) interfaces
 1 terminal line
 1 Virtual Private Network (VPN) Module
 1 cisco ids sensor(s), ids monitoring on slot 1
 32K bytes of NVRAM.
 32768K bytes of processor board System flash (Read/Write)
 
 CEF и Flow switching включены на всех субинтерфейсах. Hа Serial один 
 субинтерфейс, Frame Relay, с crypto-map, но там трафика почти нет.
 
 With best regards, Alexander V. Klepikov.  E-mail: klepikov_a@up.ua 
 --- ifmail v.2.15dev5.3
  * Origin: Demos online service (2:5020/400)
 
 

Вернуться к списку тем, сортированных по: возрастание даты  уменьшение даты  тема  автор