|
ru.cisco- RU.CISCO --------------------------------------------------------------------- From : Michael Smirnov 2:5020/400 31 Oct 2001 20:12:38 To : Michael Smirnov Subject : Re: 2509 aux --------------------------------------------------------------------------------
> > MS> Я спаял переходних RJ45<->DB25, чтобы подключить
> > MS> модем Courier V.Everything к Aux порту на Cisco 2509.
> > MS> Hо после дозвона коннекта не происходит.
> > MS> После попытки зайти на модем обратным телнетом
> > MS> aux-порт выдает значок "~" и зависает - больше на него не зайти,
> > MS> лечится перезагрузкой циски.
> Я имею в виду кабель для втыкания прямо в циску и в модем.
>
>----- Original Message -----
>From: BOJIKA
>
>RJ45-RJ45--DB25
>1-------8-------4
>2-------7-------20
>3-------6-------2
>4-------5-------7
>5-------4-------7
>6-------3-------3
>7-------2-------8
>8-------1-------5
>
>вот это так выглядит....
>цисковский кабель rollover + переходник....
У меня так и спаяно.
Куда копать-то?!
Что означает CTS со звездочкой и "Async9 is administratively down"?
gw#s line 9
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
Int
I 9 AUX 38400/38400 - inout - - - 1 0
0 -
Line 9, Location: "", Type: "vt100"
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 38400/38400, no parity, 1 stopbits, 8 databits
Status: Ready, Connected, Rcvd BREAK, CTS Raised, Modem Signals Polled
Capabilities: Notification Set, Hardware Flowcontrol In,
Hardware Flowcontrol Out, Modem Callout, Modem RI is CD,
Line usable as async interface
Modem state: Ready
Group codes: 0
Modem hardware state: CTS* noDSR DTR RTS
TCP/IP header compression enabled
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:00:30 never 06:00:00 not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: 1d21h
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are lat pad v120 mop telnet rlogin udptn nasi.
Allowed output transports are lat pad v120 mop telnet rlogin nasi.
Preferred transport is lat.
No output characters are padded
No special data dispatching characters
gw#s int async 9
Async9 is administratively down, line protocol is down
Hardware is Async Serial
Interface is unnumbered. Using address of Ethernet0 (194.190.248.1)
MTU 512 bytes, BW 112 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (30 sec)
DTR is pulsed for 5 seconds on reset
LCP Closed
Closed: IPCP, CCP
Last input never, output never, output hang never
Last clearing of "show interface" counters 6d23h
Queueing strategy: fifo
Output queue 0/10, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
--- ifmail v.2.15dev5
* Origin: Demos online service (2:5020/400)
Вернуться к списку тем, сортированных по: возрастание даты уменьшение даты тема автор
Архивное /ru.cisco/27252efe8ede0.html, оценка из 5, голосов 10
|