ru.cisco

 
 - RU.CISCO ---------------------------------------------------------------------
 From : oleg                                 2:5020/400     24 Mar 2003  18:38:50
 To : Andrew Lutov
 Subject : Re: Cisco 5350 - введение в экспуатацию :(
 -------------------------------------------------------------------------------- 
 

 Step-by-Step Procedure
   1.. Attach a terminal or PC with terminal emulation to the console port of
 the router. Use the following terminal settings:
     9600 baud rate
     No parity
     8 data bits
     1 stop bit
     No flow control
 
     1.. If you still have access to the router, type show version and record
 the setting of the configuration register; it is usually 0x2102 or 0x102.
 Click here to see the output of a show version command.
 
     2.. If you don't have access to the router (because of a lost login or
 tacacs password), you can safely consider that your configuration register
 is set to 0x2102.
 
     3.. Using the power switch, turn off the router and then turn it back
 on.
     Important: To simulate step 4 on a Cisco 6400, pull out and then replace
 the Node Route Processor (NRP) or Node Switch Processor (NSP) card.
 
     Important: To simulate step 4 on a Cisco 6x00 using NI-2, pull out and
 then replace the NI-2 card.
 
     4.. Press Break on the terminal keyboard within 60 seconds of the
 power-up to put the router into ROMMON.
     If the break sequence doesn't work, see Possible Key Combinations for
 Break Sequence During Password Recovery for other key combinations.
 
     5.. Type confreg 0x2142 at the rommon 1> prompt to boot from Flash
 without loading the configuration.
 
     6.. Type reset at the rommon 2> prompt.
     The router reboots but ignores its saved configuration.
 
     7.. Type no after each setup question or press Ctrl-C to skip the
 initial setup procedure.
 
     8.. Type enable at the Router> prompt.
     You'll be in enable mode and see the Router# prompt.
 
     9.. Important: Type configure memory or copy startup-config
 running-config to copy the nonvolatile RAM (NVRAM) into memory. Do not type
 configure terminal.
 
     10.. Type write terminal or show running-config.
     The show running-config and write terminal commands show the
 configuration of the router. In this configuration you see under all the
 interfaces the shutdown command, which means all interfaces are currently
 shutdown. Also, you can see the passwords (enable password, enable secret,
 vty, console passwords, and so on) either in encrypted or unencrypted
 format. The unencrypted passwords can be re-used, the encrypted ones will
 have to be changed with a new one.
 
     11.. Type configure terminal and make the changes.
     The prompt is now hostname(config)#.
 
     12.. Type enable secret <password> to change the enable secret password,
 for example.
 
     13.. Issue the no shutdown command on every interface that is used. If
 you issue a show ip interface brief command, every interface that you want
 to use should be "up up".
 
     14.. Type config-register 0x2102, or the value you recorded in step 2.
 
     15.. Press Ctrl-z or end to leave the configuration mode.
     The prompt is now hostname#.
 
     16.. Type write memory or copy running-config startup-config to commit
 the changes.
 --- ifmail v.2.15dev5
  * Origin: Demos online service (2:5020/400)
 
 

Вернуться к списку тем, сортированных по: возрастание даты  уменьшение даты  тема  автор