Главная страница


ru.cisco

 
 - RU.CISCO ---------------------------------------------------------------------
 From : Vladimir Khazhanez                   2:5020/400     22 Oct 2002  10:33:23
 To : All
 Subject : how to configure ethernet subinterface
 -------------------------------------------------------------------------------- 
 
 Всем привет
 
 Имеется киса 2620 IOS Version 12.1(3r)T2
 Hужны сабинтерфейсы не фастезернете.
 
 Читал доки на киско.ком, делал по ним - не получается.
 Может я чего-то упустил, или данный иос этого не поддерживает ?
 Тогда что надо влить в кису?
 
 ---------------- конфиг езера --------------
 interface FastEthernet0/0
  ip address   х.х.х.х   х.х.х.х
  no ip directed-broadcast
  duplex auto
  speed auto
 !
 interface FastEthernet0/0.1
  no ip directed-broadcast
 !
 -----------------------------------------------
 
 пытаюсь прикрутить ИП на interface FastEthernet0/0.1
 
 Router#conf t
 Enter configuration commands, one per line.  End with CNTL/Z.
 Router(config)#int fa 0/0.1
 Router(config-subif)#ip address 1.1.1.1 255.255.255.0
 
 Configuring IP routing on a LAN subinterface is only allowed if that
 subinterface is already configured as part of an IEEE 802.10, IEEE 802.1Q,
 or ISL vLAN.
 Router>sh ver
 
 Cisco Internetwork Operating System Software
 IOS (tm) C2600 Software (C2600-I-M), Version 12.0(7)T,  RELEASE SOFTWARE
 (fc2)
 Copyright (c) 1986-1999 by cisco Systems, Inc.
 Compiled Tue 07-Dec-99 02:12 by phanguye
 Image text-base: 0x80008088, data-base: 0x807AAF70
 
 ROM: System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)
 
 Router uptime is 19 weeks, 4 days, 20 hours, 51 minutes
 System returned to ROM by power-on
 System restarted at 11:52:25 Ukr Thu Jun 6 2002
 System image file is "flash:c2600-i-mz.120-7.T"
 
 cisco 2620 (MPC860) processor (revision 0x600) with 26624K/6144K bytes of
 memory.
 Processor board ID JAD05450KAM (3315191087)
 M860 processor: part number 0, mask 49
 Bridging software.
 X.25 software, Version 3.0.0.
 1 FastEthernet/IEEE 802.3 interface(s)
 4 Serial(sync/async) network interface(s)
 32K bytes of non-volatile configuration memory.
 8192K bytes of processor board System flash (Read/Write)
 
 Configuration register is 0x2102
 
 --- ifmail v.2.15dev5
  * Origin: Demos online service (2:5020/400)
 
 

Вернуться к списку тем, сортированных по: возрастание даты  уменьшение даты  тема  автор 

 Тема:    Автор:    Дата:  
 how to configure ethernet subinterface   Vladimir Khazhanez   22 Oct 2002 10:33:23 
 Re: how to configure ethernet subinterface   Vladimir Khazhanez   22 Oct 2002 10:45:51 
 Re: how to configure ethernet subinterface   Sergey Goncharov   22 Oct 2002 13:35:46 
 Re: how to configure ethernet subinterface   Oleg V.Ermakov   28 Oct 2002 12:14:43 
 Re: how to configure ethernet subinterface   Tima Maryin   28 Oct 2002 12:37:21 
 Re: how to configure ethernet subinterface   Irakli Natsvlishvili   28 Oct 2002 21:43:15 
 Re: how to configure ethernet subinterface   Cherkashin Dmitry   22 Oct 2002 11:00:20 
 Re: how to configure ethernet subinterface   Alexandre Snarskii   22 Oct 2002 11:04:25 
 Re: how to configure ethernet subinterface   Vitaly Markitantov   22 Oct 2002 11:54:02 
 Re: how to configure ethernet subinterface   Anton Morozov   22 Oct 2002 12:00:16 
Архивное /ru.cisco/1134603a6f0a2.html, оценка 3 из 5, голосов 10
Яндекс.Метрика
Valid HTML 4.01 Transitional